
©
2001 - 2002
For information and use,
contact Peter Vogel
pvogel@together.net

Chapters
in PDF format
Webmaster: webmaster@portchicago.org
|

Document Transcriptions:
The liquid thermal diffusion uranium isotope separation method.
"Pursuant
to attached letter of June 3 from Gen. Groves, JBC and W. K. L. [Warren
K. Lewis] Discussed with E. O. L. & the top [Oak Ridge] Tennessee
people the relation of the NRL process (later to be called the Abelson-Gunn
process) to the electromagnetic process. It was agreed that the use of
the expanded Phila. [Philadelphia] plant to produce 0.70% feed was of
first importance and by itself would increase the output before July 1,
1945 appreciably. The question was also raised of building a NRL plant
to operate on the [boiler] house of the [gaseous] diffusion plant at Tennessee.
It was pointed out that for small enrichment this process was economical
but for large enrichment almost impossible because of coal consumption
and long hold-up time. it was recommended to Gen. Groves that a plant
be built at Tennessee to feed in the electromagnetic plant enriched material
thereby perhaps doubling the output of providing insurance against failure
of the [gaseous] diffusion plant to come in on time."
1944, July 27
Manuscript of James Conant, "Historical note on introduction of the
Abelson-Gunn process."
Photo Credit:
"Curves give
the anticipated possible production of the Navy plant, with the 100
tubes connected in parallel, based on the data presented in Columbia
Report No. 4-R-104 for tubes and operating conditions at NRL most nearly
comparable to those to be used at Philadelphia."
Source:
National Archives.
Attached to 1944, June 3 Memorandum of Mssrs. W. K. Lewis, E. V. Murphree
and R. C. Tolman to Major General L. R. Groves. SECRET.
Subject: Possible Utilization of Navy Pilot Thermal Diffusion Plant
|